Videolarm EcoKit Manual Del Usuario página 20

Controller in operation mode, the indicator will show the different status of the operation of equipment, detailed in the table below:
Internal Dump Load:
L1, L2, L3 (Green)
L1, L2 (Green)
L1 (Green)
L1 (Green)
(Green)
≈ (Red)
(Green)
(Green)
4.0 Notes
4.1
Ordering Information.
4.1.1
Order should be detailed description of equipment configuration requirements, such as: generator sets parameters, technical parameters of solar cell
components, the choice of external dump loading devices, protective grading, as well as overload protection.
4.1.2
Use under special conditions, can be customized in accordance with the usage conditions of users.
4.2
Installation Notes.
4.2.1
Before accessing controller to confirm the system equipment, such as, wind turbine,solar components, batteries, lightning protection devices, cable selection
configuration is correct, accurate installation.
Indication Lamp Display Status
L1, L2, L3
000
100
010
110
001
101
011
111
4.2.2
Check-to-ground insulation resistance of equipment should be in line with the wind / light generating system of technical requirements.
4.2.3
Installation, disassembly, repair equipment, wind turbine will be sure to manually switch the brake to the "|" position.
4.3
ST setting mode.
External Dump Load:
L1, L2, L3 (Green)
L1, L2 (Green)
L1 (Green)
L1 (Green)
(Green)
(Red)
(Green)
(Green)
Merit Can
Continuous power supply to open
Darkness that is open, dawn Close
2 hours after dark, full power, half power 2 hours
3 hours after dark, full power, half power 3 hours
4 hours after dark, full power, half power 4 hours
5 hours after dark, full power, half power 5 hours
6 hours after dark, full power, half power 6 hours
8 hours after dark, full power, half power 8 hours
LED Descriptions
State:
Lights
Lights
Lights
Blinks
Lights
Lights
Lights
Lights
Explanation:
Full battery capacity
Normal battery capacity
Low battery capacity
Battery exhausted
Wind turbine generator is working
Dump load
PV Module is working
Output normal