Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Checking/Replacing the fuses
!
ATTENTION!
Before replacing the fuses contact the authorised service centre.
DO NOT replace fuses with diff erent amperage.
•
Open the door of the battery compartment, pull out the battery holder case and disconnect the batteries. (see
section" Opening/Closing the battery holder case and disconnecting the battery connector)
•
Remove the screw (F) with a crosshead screwdriver and open the panel (G) by holding its handle and disenga-
ging it from its lower pins (H).
Check / Replace the fuses as below:
•
3A starter key switch main fuse ( I ) and 80A main fuse (L).
•
Insert the panel (G) by engaging it in its lower pins (H).
•
Fasten the screw (F) again.
•
Reconnect the batteries and push them into the battery holder case and close the door.
G
80A
80A
L
F
38
3A
3A
Publicidad
Capítulos
Tabla de contenido
