Connecting An Additional Amplifier - Pioneer A-A9MK2-K Manual De Instrucciones

Other connections
Important
If you have followed the steps above, and still
can't hear any audio output, try the following:
• Switch the amplifier off, then on again.
• Selecting another input source (like CD or
TAPE), then back to USB.
Caution
• Make sure you don't switch off the
computer or unplug the USB cable during
playback.
• To prevent noise being output, don't use
other software on your computer during
playback.
• Pioneer is not responsible for computer
system damage, software crashes or
failures, or any other possible computer
problems due to this configuration.
® ®
Microsoft , Windows Vista, Windows
®
2000, Windows Millennium Edition and Windows
Second Edition are either registered trademarks or
trademarks of Microsoft Corporation in the United States
and/or other countries.
Connecting an additional
amplifier
This amplifier has more than enough power for
any home use, but it's possible to add an
additional amplifier using the pre-outs. Make
the connections shown below to add an
amplifier to power your speakers.
• Before making or changing the
® ®
XP, Windows
®
98
connections, switch off the power and
disconnect the power cord from the AC
outlet.
REC PLAY
OUT IN
PRE
TAPE TUNER
OUT
Stereo amplifier
CONTROL
USB
OUT
AUDIO IN
SIGNAL
GND
L L
R R
MM/MC
AUX CD PHONO
This amplifier
INPUT
R L
ANALOG
05
15
En