Stiga BL 320E Manual De Instrucciones página 86

WARNING: READ THE INSTRUCTION BOOKLET THOROUGHLY BEFORE USING THE MACHINE.
EN
Keep for future reference.
INDEX
1. GENERAL INFORMATION ........................................... 1
1.1 How to read the manual ....................................... 1
1.2 References .......................................................... 1
2. SAFETY REGULATIONS ............................................. 2
2.1 Training ................................................................ 2
2.2 Preparation .......................................................... 2
2.3 During operation .................................................. 2
2.4 Maintenance, storage .......................................... 3
2.5 Environmental protection ..................................... 3
3. GETTING TO KNOW THE MACHINE .......................... 3
3.1 Description of the machine and planned use ...... 3
3.2 Safety signs ......................................................... 4
3.3 Identification label ............................................... 4
3.4 Main components ............................................. 4
4. ASSEMBLY ......................................................................... 4
4.1 Assembly components ........................................ 5
4.2 Grass-catcher assembly ................................... 5
4.3 Handle assembly .............................................. 5
5. CONTROLS .............................................................. 5
5.1 Control lever ........................................................ 5
5.2 Cutting height adjustment .................................... 5
6. USING THE MACHINE ................................................. 5
6.1 Preparation ...................................................... 5
6.2 Safety checks................................................... 6
6.3 Start-up ............................................................ 6
6.4 Working ................................................................ 6
6.5 Stop 7
6.6 After operation ................................................. 7
7. ROUTINE MAINTENANCE ........................................... 7
7.1 General information .......................................... 7
7.2 Cleaning............................................................... 7
7.3 Nuts and bolts ...................................................... 7
8. OCCASIONAL MAINTENANCE ................................... 7
8.1 Cutting means .................................................. 7
8.2 Power cable ......................................................... 8
9. STORING ...................................................................... 8
9.1 Storing ................................................................. 8
10. HANDLING AND TRANSPORTATION ......................... 8
11. ASSISTANCE AND REPAIRS ...................................... 8
12. WARRANTY COVERAGE ............................................ 9
13. MAINTENANCE TABLE ................................................ 9
14. PROBLEM IDENTIFICATION ..................................... 10
1. GENERAL INFORMATION
HOW TO READ THE MANUAL
1.1
Some paragraphs in the manual contain important
information regarding safety and operation
and are emphasized in this manner:
NOTE OR IMPORTANT
information on what has been previously indicated and aim
to prevent damage to the machine or cause other damage.
The symbol highlights danger. Failure to
observe the warning can lead to the risk of injury
to oneself and others and/or damage.
The paragraphs inside a grey dotted frame
refer to optional features not available on all
the models referred to in this booklet. Check
if the feature is available on your model.
Whenever reference is made to a position on the
machine such as "front", "back", "left" or "right"
hand side, this is determined from where the
operator is in normal operating position.
REFERENCES
1.2
Figures
1.2.1
The figures in these instructions for
use are numbered 1, 2, 3, etc.
The components indicated in the figures are
identified with letters A, B, C, and so on.
Reference to component C in figure 2 is indicated with
the wording: "See fig. 2.C" or simply "(Fig. 2.C)".
The figures are given as a guide only. The actual
pieces can differ from those illustrated below.
Titles
1.2.2
The manual is divided into chapters and paragraphs.
The title of paragraph "2.1 Training" is a sub-title of "2.
Safety regulations". References to titles or paragraphs
are marked with the abbreviation chap. or par. and the
relevant number. Example: "chap. 2" or "par. 2.1.
EN - 1
These give details or further