Steelcase High-Density Storage Instrucciones De Montaje página 8

®
Storage-to-Panel
Connector
(continued)
5.
On the back of the storage
unit, locate the corner that the
bracket assembly will attach to
the panel. Measure from the
floor and mark a line on the back
of the storage unit that is the
same distance as measured in
step 4.
6.
Next, we will use the bracket
assembly as a marking template.
Remove the bracket assembly
from the panel. Flip the bracket
assembly upside down and nest
in the corner of the storage unit
(6a). Center the marked line in
the small hole as shown (6b).
Mark all small holes on the
bracket assembly (6c). There will
be two (2) holes for tall & low
and three (3) holes for medium.
5
FLOOR
6a
MEASURED
DIMENSION
FROM STEP 4
6b
6c
BRACKET
ASSEMBLY
Page 8 of 39
76456 Rev C