PEERLESS Mounts SmartMount SA735P Instalación Y Montaje página 8

Mounting and Removing Flat Panel Screen
• Always use an assistant or mechanical lifting equipment to safely lift and position the fl at panel screens.
Hook adapter brackets (B) onto adapter plate (A).
3
Turn security screws, using phillips screwdriver,
clockwise at least six times to prevent screen from
being removed as shown in cross section of fi g. 3.1.
NOTE: To lock the screen down, tighten security
screws to adapter plate as shown in cross section.
To remove screen from mount, loosen security
screws, swing screen away from mount, and lift
screen off of mount.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
If more or less tension is desired in tilt mechanism,
4
remove snap caps as shown in detail 1. Insert a fl at
head screwdriver into slot and pry cap away from tilt
mechanism. To adjust tilt, tighten or loosen socket
screw no more than half a turn using allen wrench
(N).
To adjust roll (5° left or right), tighten or loosen
10-32 x 1/2" phillips screw.
WARNING
• If screws become loose over time, tighten screws
as necessary. Tighten screws to 50 in • lbs
(5.6 N.m.) maximum torque.
WARNING
B
CROSS SECTION
SOCKET
SCREW
SNAP
CAP
8 of 42
A
SECURITY
SCREWS
SLOT
DETAIL 1
ISSUED: 02-15-10 SHEET #: 095-9315-2 04-26-10
B
A
fi g 3.1
10-32 X 1/2"
SCREW