Technical Specifications - Metabo PE 12-175 Manual Original

en ENGLISH

14. Technical Specifications

Explanation of details on page 3. Subject to
changes serving technical progress.
D = Maximum support plate diameter
max
M = Maximum torque
t, max
M = Spindle thread
l = Length of the grinding spindle
n* = No-load speed (maximum speed)
n * = Speed at rated load
N
P = Nominal power input
1
P = Power output
2
m = Weight without mains cable
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~
AC Power
* High-energy, high-frequency interference can
cause speed fluctuations of up to 20%, which
subside when the interference disappears.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or lower.
For assessment purposes, please allow for breaks
and periods when the load is lower. Based on the
adjusted estimates, arrange protective measures
for the user e.g. organisational measures.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a = Vibration emission value (polishing)
h, P
K = Uncertainty (vibration)
h,P
Typical A-effective perceived sound levels:
L = Sound-pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
14