Cooke & Lewis CLIND60RF Manual Del Usuario página 40

WARNING: Always switch off the electricity supply before performing maintenance work.
In the event of a fault, contact customer services.
Damaged power cables should be replaced by a competent person or qualifi ed electrician.
For domestic use only.
Never place an empty pan on the hob as this will cause the overheat sensor to switch off
the appliance automatically.
When a cooking zone has been on for a long time, the surface remains hot and shows "H"
in the display.
If the surface of the hob becomes cracked, do not use, switch off the appliance at the fused
spur and contact customer services.
Do not place rough or uneven vessels on the hob, as they could damage the glass surface.
Avoid banging pots and pans down on the hob. The induction surface is tough but
not unbreakable.
Do not put detergents or fl ammable materials beneath the hob.
• The appliance should be cleaned after use, allow to cool fi rst!
• The surface of the induction hob should be cleaned as follows:
Type of dirt
Limescale
Burnt-on stains
Light stains
Melted plastics
Cuidados y Mantenimiento
Cleaning method
Apply white vinegar to the surface,
then wipe it dry with soft cloth
Clean with damp cloth and dry it
with a soft cloth
Clean with damp cloth and dry it
with a soft cloth
Use a scraper suitable for induction
glass to remove residue
ș ț
Cleaning materials
Special induction cleaner
Special induction cleaner
Cleaning sponge
Special induction cleaner
40