Safety Information - LIMIT 310 Manual Del Usuario

SAFETY INFORMATION

GB
1. Safety certification
This Meter strictly follows the CE standards: EN 61010-1: 2010, EN 61010-2-030:2010,
EN 61326:2013, as well as CAT II 250 V, RoHS, pollution grade II, and double insulation
standards.
2. To prevent possible electrical shock, fire, or personal injury
2.1 Do not use the Meter if it is damaged or if the Meter is not operating properly. Inspect
the case before use the Meter and look for cracks or missing plastic. Pay attention to
the insulation layers.
2.2 If the test leads are damaged, it must be replaced with one of the same type or the
same electrical specification.
2.3 When measuring, do not touch exposed wires, connectors, unused inputs, or the
circuit being measured.
2.4 When measuring the voltage higher than 60 VDC or 30 VAC rms, keep your fingers
behind the finger guard on the test lead to prevent electric shock.
2.5 If the range of the voltage to be measured is unknown, the maximum range should be
selected and then gradually decreased.
2.6 Never apply more than the rated voltage and current exceeding the value as marked
on the Meter.
2.7 Before switching ranges, make sure to disconnect the test leads with the circuit to be
tested. It is strictly prohibited to switch the ranges during the measurement.
2.8 Do not use or store the Meter in high temperature, high humidity, flammable,
explosive or strong magnetic field environments.
2.9 Do not change the internal circuit of the Meter to avoid the damage to the Meter and
users.
2.10 To avoid false reading, replace the battery as soon as the battery indicator
appears.
2.11 Use dry doth to dean the case, do not use detergent containing solvents.
2.12 The maintenance and service must be conducted by qualified professionals or
designated departments.
3. Battery replacement (See picture F)
3.1 Switch the dial to "OFF "position and remove the test leads from the Input terminal.
3.2 Take off the protective case. Loosen the screw on battery cover, remove the cover to
replace with 2 pieces AAA batteries. Please identify the positive and negative pole.
2