Cosatto nitty gritty Manual De Instrucciones página 7

Handle:
8: Adjusting:
Handle positions:
In vehicle/Carry position,
1:
Hood:
9: Opening:
10: Closing:
11: Removing hood fabric:
Refitting is a reversal of this procedure.
12: Removing hood fabric insert:
Refitting is a reversal of this procedure.
Securing your child in the child car seat:
13:
Open the harness (a),
Raise the headrest (b), (refer
14: Place your child in the child car seat.
Close the harness (a),
Adjust the headrest (b), (refer
Tighten the harness (c), (refer
NOTE: The harness must be reasonably tight. It should restrain but not make the
child uncomfortable. Check that the straps are not twisted while the child is seated.
15: Satisfactory shoulder strap position:
16: Satisfactory crotch strap position:
Fitting the child car seat to your vehicle:
17:
Adjust the handle to vehicle/Carry position (a) (refer to steps 8).
Position the child car seat on the vehicle seat, pass the vehicle waist belt through
the side vehicle belt guides (b) and fasten the vehicle belt buckle (c).
Route the diagonal belt under handle hinge (d) then through rear vehicle seat belt
guide (e).
Tension the vehicle diagonal belt (f ).
IMPORTANT: The position of the vehicle belt buckle can affect
the stability of the child car seat. In an accident this could stop
the child car seat from protecting your child as well as it should.
After tightening the vehicle belt, if the buckle lies in the position
marked then try fitting the child car seat in another seating
position in your vehicle. If in doubt consult either the child car
seat manufacturer or retailer.
Removing softgoods:
18:
Open the harness,
Remove the seat liner (a) (if applicable) & crotch pad (b).
19:
Remove the hood fabric
Remove the chest pads (b) & headrest (c).
Stow/Reclined Cradle position,
2:
(refer to step 3).
to step 5).
(refer to step 4).
to step 5).
to step 2).
(refer to step 3).
(a), (refer to step 11).
5
Steady position.
3: