Descargar Imprimir esta página

scenearama SP4120 Instrucciones página 2

Publicidad

IMPORTANT: READ THROUGH INSTRUCTIONS COMPLETELY to
understand the basic concepts. There are hundreds of ways to build a
scene, so PLAN AHEAD to make the most of the materials. Have fun
and use your imagination!
1. Ground Cover
• Mix Project Glue and water in Spray Bottle (Fig. 1a).
• Mist Project Glue on ReadyGrass Sheet where you would like
grasses (Fig. 1b).
• Sprinkle Green Grass to add texture and highlights (Fig. 1c).
• Sprinkle Forest Green Accent for paths or damp areas.
• Mist Project Glue over grassy areas to seal.
NOTE: Project Glue dries clear and matte.
2. Undergrowth and Bushes
• Separate Foliage Fiber into layers. Stretch each layer until thin and
lacy. (Fig. 2a)
• Apply Project Glue where you would like undergrowth and Bushes
(Fig. 2b).
• Press Foliage Fiber and Bushes into Project Glue (Fig. 2c). Bushes
look better in groups. Use under trees and along paths.
• Sprinkle Green Grass and Forest Green Accent onto Foliage Fiber
(Fig. 2d), then mist with Project Glue to seal.
3. Tall Grasses
• Place a small amount of Project Glue on a piece of paper.
Remove a pinch of Wild Grass from package and roll it between
your fingers to produce an uneven look. Cut with scissors to
the length you want (Fig. 3a).
• Dip cut end of Wild Grass into Project Glue (Fig. 3b).
• Place Wild Grass in desired locations (Fig. 3c).
• Hold until setting begins.
4. Flowers
• Sprinkle Yellow Flowers where you want flowers. Add to fields,
vines, bushes and trees (Fig. 4a).
• Mist Project Glue on flowers (Fig. 4b).
Fig. 3a
Fig. 3b
Fig. 3c
Fig. 1a
Spray Glue Formula /
Formule de la colle en vaporisateur /
Fórmula de
pegamento para
rociar
4.
Fill with
4.
FULL
4.
Remplir
Llenar
water
d'eau et
con
PLEINE
and
agua y
agiter
shake
LLENO
agitar
3.
Shake
3.
Agiter
3.
Agitar
2.
Add
2.
Ajouter
2.
Añadir
Project
Project
Project
Glue
Glue
Glue
1.
Add
1.
Ajouter
1.
Añada el
water
l'eau
agua
Fig. 1b
Fig. 2a
Fig. 2b
Fig. 2c
4.
Mit
FULL
Wasser
gefüllt
und
schütteln
3.
Schütteln
2.
Hinzufügen
Project
Glue
1.
Wasser
hinzufügen
Fig. 1c
Fig. 2d
Fig. 4a
Fig. 4b

Publicidad

loading