Low Battery; Lock Button - TensCare itouch sure Manual Del Usuario

This is a safety feature to alleviate any
sudden feeling of a surge, as each
programme gives a different sensation.
TREATMENT TIMER
The TIMER button can be
T
used to set
duration. When you switch the
unit on, it is automatically set at 20
minutes for all the programmes.
By repeatedly pressing and releasing
the TIMER button you can manually
override and select 10, 20, 30, 45, 60,
90 minutes or continuous time.
The length of time that you have
selected will be shown on the screen.
The minutes will start to count down
once you start the programme.
If you hold down this key for 3 to 5
seconds, you can PAUSE the timer,
allowing you to interrupt the treatment
session, and resume it later. Return to
main screen by pressing any other key.
The LCD shows the session duration
next to the clock symbol. The unit
automatically counts down the minutes
set and switches off when it reaches 0.

LOW BATTERY

A low battery indicator BATT will show
when you need to change the batteries.
The unit will shut down about 2 minutes
after this.

LOCK BUTTON

The LOCK button on the top right
hand side of the unit can be used
to lock all controls except for the
▼ and OFF buttons.
To activate, press and hold down the
button for 3 to 5 seconds until LOCK is
displayed on the screen. Repeat to
deactivate.
LEADS ALARM
The
connection and the contact between
the session you and the probe, or the pads. This is
to prevent sudden changes if a broken
connection is re-made. If either of these
goes outside of a standard range while
the strength is above 20.0 mA, the unit
will flash LEADS, bleep three times,
and return the strength to 00.0 mA.
Check the lead and if necessary,
lubricate the probe with a water based
lubricant such as TensCare Go Gel
(see K-GO). Please see section 19 for
more troubleshooting tips.
MEMORY
The itouch sure has a Memory with
three functions:
1) Programme Retention. When you
switch the unit on, it will automatically
start in the programme which was being
used when it was switched off.
2) Usage. Press the TIMER button and
▲ together and hold down for 3 to 5
seconds. The display will show the
duration of use in minutes/10' and the
average strength used.
Press the same buttons again to return
to normal controls.
3) Memory Reset. To reset memory to
zero, hold down the TIMER and ▼
buttons together for 3 to 5 seconds.
18
itouch sure monitors the