Preparing The Tube - SOMFY Sonesse 30 RTS Manual De Usuario

Sonesse 30 RTS
1] Fit the accessories required to integrate
the drive into the tube:
ð Fit the crown (a) and the wheel (b) to
the drive.
2] Measure the length (L) between the inner
edge of the drive head and the rim of the
wheel.

2.1.3.Preparing the tube

1] Cut the tube to the required length.
2] Deburr the tube and remove the debris.
2.1.4.Assembling the drive-tube
1] Slide the drive into the tube. For tubes
with a smooth interior, position the cut
notch on the crown.
2] The wheel must be locked in place to
prevent any movement in the tube.
▪ This can be achieved by fastening the tube to the wheel using self-tapping
screws, or steel pop rivets, placed between 5 mm and 15 mm from the outer
edge of the wheel, regardless of the tube.
▪ or by using a wheel lock, for non-smooth tubes.
CAUTION
The screws or pop rivets must only be fastened on the wheel and not on the
drive.
©
Copyright 2020 SOMFY ACTIVITES SA. All rights reserved.
1]
2]
1] 2]
1]
2]
EN
a
b
7