Technical Data - Blooma Brant AL117-B Manual De Instrucciones

Safety
R
These instructions are for your safety. Please read through
them thoroughly prior to installation and retain them for future
Safety
reference.
R
All fittings must be installed by a competent person in
R
These instructions are for your safety. Please read through
accordance with local regulations (IET wiring regulation
them thoroughly prior to installation and retain them for future
BS7671).
R reference.
Check the pack and make sure you have all of the parts listed.
R
R All fittings must be installed by a competent person in
Remove all packaging, wrap etc from the product.
R
accordance with local regulations (IET wiring regulation
The product must be securely fixed to the mounting surface
BS7671).
using the screws and wall plugs supplied. The screws and wall
R
Check the pack and make sure you have all of the parts listed.
plugs supplied are suitable for "masonry" only. Other fixings not
R
Remove all packaging, wrap etc from the product.
supplied and must be purchased.
R
R
The product must be securely fixed to the mounting surface
Take care not to drill into any pipes or mains cables beneath the
using the screws and wall plugs supplied. The screws and wall
surface during mounting holes preparation.
R plugs supplied are suitable for "masonry" only. Other fixings not
IMPORTANT: The fixing point(s) selected must be capable of
supplied and must be purchased.
supporting the full weight of the light fitting.
R
R
Take care not to drill into any pipes or mains cables beneath the
We recommend connecting this product to an external / wall
surface during mounting holes preparation.
switch in order to deactivate the motion detection function if
R
IMPORTANT: The fixing point(s) selected must be capable of
necessary.
R
supporting the full weight of the light fitting.
Wiring diagram is for reference only. Always refer to the terminal
R
We recommend connecting this product to an external / wall
marking for wiring. Ensure that all electrical connections are tight
switch in order to deactivate the motion detection function if
and that no loose strands are left out of the terminal block.
R necessary.
When the product does not light after installation:
R
Wiring diagram is for reference only. Always refer to the terminal
> Ensure there is no electricity failure
marking for wiring. Ensure that all electrical connections are tight
> Ensure all the connections are secured
R and that no loose strands are left out of the terminal block.
If you have any doubt about installation/use of this product,
R
When the product does not light after installation:
consult a qualified electrician.
R
> Ensure there is no electricity failure
It is recommended to have a regular schedule of care and
> Ensure all the connections are secured
maintenance to keep the surface condition well.
R
If you have any doubt about installation/use of this product,
consult a qualified electrician.
R
It is recommended to have a regular schedule of care and
maintenance to keep the surface condition well.
Warranty Period and Conditions
At Blooma, we devote special attention to selecting high-quality materials and use manufacturing techniques that enable us to create
designer and durable product ranges.
Warranty Period and Conditions
That is why we offer a 2-year warranty against product manufacturing defects. This product is under warranty for 2 years as from the date of
purchase, for normal, non-professional household use. The warranty shall only apply upon presentation of the till receipt or the invoice. Keep
At Blooma, we devote special attention to selecting high-quality materials and use manufacturing techniques that enable us to create
your proof of purchase in a safe place.
designer and durable product ranges.
The warranty covers product breakdowns and malfunctions under the condition that the product is used in accordance with its intended use
That is why we offer a 2-year warranty against product manufacturing defects. This product is under warranty for 2 years as from the date of
and subject to installation and maintenance in accordance with good practice and the information contained in the user's manual.
purchase, for normal, non-professional household use. The warranty shall only apply upon presentation of the till receipt or the invoice. Keep
This product must be installed so that it may be later removed without damaging it.
your proof of purchase in a safe place.
This contractual warranty does not cover defects and damage caused by the natural wear of parts, bad weather, flooding, heat releases,
The warranty covers product breakdowns and malfunctions under the condition that the product is used in accordance with its intended use
freezing, damage caused by water quality (hardness, aggressiveness, corrosion, etc.), by the presence of foreign bodies transported by
and subject to installation and maintenance in accordance with good practice and the information contained in the user's manual.
water or otherwise (sand, filings, etc.) or the lack of room ventilation, and damages that could be the consequence of improper use, misuse,
This product must be installed so that it may be later removed without damaging it.
negligence, accident or maintenance that is defective or does not comply with good practice or the information in the user's manual.
This contractual warranty does not cover defects and damage caused by the natural wear of parts, bad weather, flooding, heat releases,
The following are also excluded from the warranty: harmful consequences due to the use of accessories and/or non-original equipment
freezing, damage caused by water quality (hardness, aggressiveness, corrosion, etc.), by the presence of foreign bodies transported by
manufacturer or improper replacement parts, disassembly or product modification.
water or otherwise (sand, filings, etc.) or the lack of room ventilation, and damages that could be the consequence of improper use, misuse,
The warranty is limited to those parts recognised as defective. Under no circumstances shall it cover fringe expenses (travel, labour) and
negligence, accident or maintenance that is defective or does not comply with good practice or the information in the user's manual.
direct and consequential damage.
The following are also excluded from the warranty: harmful consequences due to the use of accessories and/or non-original equipment
Guarantee related queries should be addressed to a store affiliated with the distributor you purchased the product from.
manufacturer or improper replacement parts, disassembly or product modification.
This guarantee is in addition to and does not affect your statutory rights.
The warranty is limited to those parts recognised as defective. Under no circumstances shall it cover fringe expenses (travel, labour) and
direct and consequential damage.
Guarantee related queries should be addressed to a store affiliated with the distributor you purchased the product from.
This guarantee is in addition to and does not affect your statutory rights.
3663602893424_3663602893431-Blooma-A5-IM-V04.indb 3

Technical Data

Supply Voltage: 220-240 V~, 50/60 Hz
Technical Data
1000 W for incandescent;
Max. switching
300 W for fluorescent;
capacity:
150 W for LED
Supply Voltage: 220-240 V~, 50/60 Hz
This product complies with conformity
1000 W for incandescent;
Conformity with all relevant EC Directive
Max. switching
requirements of the applicable European
300 W for fluorescent;
requirements.
capacity:
Regulations or Directives.
150 W for LED
IP44
This product complies with conformity
Splash-proof.
Conformity with all relevant EC Directive
requirements of the applicable UK
requirements.
Regulations.
Waste electrical products should not be
disposed of with household waste. Please
IP44
recycle where facilities exist. Check with your
Splash-proof.
Local Authority or local store for recycling
Waste electrical products should not be
advice.
disposed of with household waste. Please
recycle where facilities exist. Check with your
This product is not suitable for dimming.
Local Authority or local store for recycling
advice.
xxWyy xx-year; yy-week of the year
This product is not suitable for dimming.
xxWyy xx-year; yy-week of the year
18/11/2017 10:51