Battery Safety - Plantronics CT10 Manual De Usuario

CT10MultiLangInside.R1 7/3/00
IMPORTANT SAFETY INSTRUCTIONS
14. Unplug this product from the wall outlet and refer
servicing to qualified service personnel under the
following conditions
a) When the power supply cord or plug is damaged or frayed.
b) If liquid has been spilled into the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the
operating instructions because improper adjustments of other
controls may result in damage and will often require extensive work
by a qualified technician to restore the product to normal operation.
e) If the product has been dropped or the base unit has been
damaged.
f) If the product exhibits a distinct change in performance.
15. This product requires AC power in order to operate. In order to
have phone service during a power outage, have another telephone
available that is powered only by the telephone line.
16. Keep all product cords and cables away from operating
machinery.
2:20 PM Page 4
4
IMPORTANT SAFETY INSTRUCTIONS

BATTERY SAFETY

CAUTION: To reduce the risk of fire or injury to persons, read and
follow these instructions.
1. Use only the battery pack supplied with this product.
2. Do not dispose of battery pack in a fire. The cells may explode.
Check with local codes for possible disposal instructions.
3. Do not open or mutilate battery pack. Released electrolyte is corro-
sive and may cause damage to eyes or skin and may be toxic if
swallowed.
4. Exercise care in handling the battery pack in order not to "short" the
battery contacts with conducting materials such as rings, bracelets,
and keys. The battery or conductor may overheat and cause burns.
5. Charge the battery pack in accordance with instructions supplied
with this unit.
6. Observe proper orientation between battery pack and charger con-
tacts.
7. Contact your local, county, or state hazardous waste management
authorities for information on recycling or disposal programs in your
area.
8. Important: The new battery pack must be attached to the Remote
and charged in the Charging Well
3
Light goes off before it can be used away from the Base
23
9. The maximum standby time for a freshly charged battery pack is
approximately 7 days. The maximum talk time is approximately 6
hours.
SAVE THESE INSTRUCTIONS
5
until the Charge Indicator
24
.
19