THERMEx DAX Instrucciones De Montaje página 49

M 540235068209082018
INSTALLING THE DUcT
If the hood is to be installed with the exhaust venting into the open air, the duct is installed as follows:
1
x2
Measure the placement of the bracket and
mark the position of the holes on the wall.
NOTE: The bracket must be positioned so
that it matches the holes in the duct.
4
Place the duct on the hood.
2
x2
x2
Pre-drill the holes and insert the rawlplugs.
5
Push the topmost section of the duct up-
wards and attach it to the bracket with two
self-tapping screws.
THERMEX DAx
3
Screw the bracket onto the wall.
6
Attach the lowermost part of the duct se-
curely to the brackets on the hood using two
self-tapping screws.
49