Philips Supervapor 40 Manual Del Usuario página 6

- Close the steam tank
by turning the screw
cap clockwise by hand
until tight (fig. 3).
If you begin ironing
- Fill the steam tank before inserting the mains
plug into the wall socket.
While ironing
Caution: If heated-up, the steam tank will be
under pressure.
Only refill if the steam tank is empty (i.e. when
no more steam comes from the soleplate during
steam-ironing).
- Switch the iron off by
setting switch (C) to
position O (fig. 4).
- Switch the steam tank
off by setting
switch (B) to position O
(fig. 5).
- Remove the mains
plug from the wall
socket.
- Using the spanner,
carefully unscrew the
cap of the steam tank
(anti-clockwise) until
you can hear steam
escaping (fig. 6).
Wait for the hissing
sound to stop.
This high-pitched sound is completely normal
and is not dangerous.
- Carefully unscrew the cap of the steam tank
further, until you hear the hissing sound again.
Wait again until the sound stops. Proceed in the
3
4
5
6
same manner until the cap is unscrewed.
- Wait for a few minutes. Then slowly pour
water into the filling opening (D) (fig. 2).
- Close the steam tank by turning the screw cap
manually (clockwise) until tight (fig. 3).
Steam-ironing
• As indicated on the temperature dial (H) and
the table, steam-ironing is only possible at
higher ironing temperatures, so set the dial to
2 or 3.
- Insert the mains plug
into a wall socket.
- Set switch "Steam
tank On/Off" (B) to
position |. The pilot
light in the switch will
come on (fig. 7).
• The iron heats up
faster than the steam
tank. Hence you can
switch on the iron a
few minutes later than
the steam tank.
- Select the required
ironing temperature
with the temperature
dial (H) (fig. 8).
- Set switch
"Iron On/Off" (C) to
position |. The pilot
light in the switch as
well as pilot light (G)
will come on (fig. 9)
- After a few minutes,
pilot light (G) will go
out. This indicates that
the soleplate has
reached the set
temperature.
- When pilot light (B) goes out, this indicates that
the steam tank is heated up and that steam is
ready. You can now start steam ironing.
- To select the required
steam output rotate
the steam control (I)
clockwise (fig. 10).
The further the control
is rotated clockwise,
the more steam is
produced.
6
7
8
9
10