Operation; Care And Cleaning - Blumfeldt 10032518 Manual De Instrucciones

OPERATION

• Connect the power cable to a supply that is located in a safe, dry area.
• To operate the heater on low (1000 W), pull the Switch Cord once. Once
the Switch Cord is pulled, one of the heating elements will glow and
radiate heat.
• To operate the heater on low (1000 W), pull the Switch Cord again, the
other heating element will glow and radiate heat.
• To operate the heater on high (2000 W), pull the Switch Cord the third
time, two heating element will glow and radiate heat the same time.
• Pull the Switch Cord the fourth time, the heater will be off.
• Although the patio heater is shower proof, do not use when raining or in
wet conditions.
• Always disconnect the power cable from the electrical supply, when the
patio heater is not in use.

CARE AND CLEANING

• Unplug the unit and let it cool completely.
• To keep the heater clean, the outer shell may be cleaned with a soft, damp
cloth.
• You may use a mild detergent if necessary. After cleaning, dry the unit with
a soft cloth.
• DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough
brushes to clean the heater. This may cause damage or deterioration to the
surface of the heater.
• Although this heater is outdoor approved, DO NOT immerse the heater in
water for your safety.
• Wait until the unit is completely dry before use.
• If the heater will not be used for a long period of time, store it in a cool, dry
location when not in use. To prevent dust and dirt build-up, use the original
packaging to repack the unit.
EN
13