Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Warning
Incorrect or out of phase engine timing can result in damage to the valves.
The Tool Connection cannot be held responsible for any damage caused
by using these tools in anyway.
Safety Precautions – Please read
•
If the engine has been identified as
an Interference engine, damage to
the engine will occur if the timing
belt has been damaged. A compresion
check of all the cylinders should be
taken before the cylinder head (s) are
removed.
•
Do not turn crankshaft or camshaft
when the timing belt has been
removed.
•
To make turning the engine easier,
remove the spark plugs.
•
Observe all tightening torques.
•
Do not turn the engine using the
camshaft or any other sprocket.
•
Disconnect the battery earth lead
(check radio code is available).
Warning – Incorrect or out of phase engine timing can result in damage
to the valves. It is always recommended to turn the engine slowly, by
hand, and to re-check the camshaft and crankshaft timing positions.
www.lasertools.co.uk
•
Do not use cleaning fluids on belts,
sprockets or rollers.
•
Some toothed timing belts are
not interchangeable. Check the
replacement belt has the correct
tooth profile.
•
Always mark the belt with the
direction of running before removal.
•
Do not lever or force the belt onto its
sprockets.
•
Check the ignition timing after the
belt has been replaced.
•
Do not use timing pins to lock the
engine when slackening
or tightening the crankshaft pulley
bolts.
•
ALWAYS REFER TO A REPUTABLE
MANUFACTURERS WORKSHOP
MANUAL
Publicidad
Tabla de contenido
