Noise/Vibration Information; Declaration Of Conformity - Wurth Master WAC 70 Traducción Del Manual Original

0701 407 2.book Seite 13 Dienstag, 9. Februar 2010 1:47 13
– When the machine is not used for a longer period
of time, the pump should not remain in the muddy
cooling water. It is better to clean the pump as
described above and leave it outside the water
container.
– Regularly check the saw flanges for wearing out
and replace if necessary.
If the machine should fail despite the care taken in
manufacturing and testing, repair should be carried
out by a Würth Master-Service agent.
For all correspondence and spare parts orders,
always include the article number on the type plate
of the machine.
For the current spare parts list of this machine, log
into the Internet under "http://www.wuerth.com/
partsmanager" or ask for a copy at your nearest
Würth branch office.
Disposal
Power tools, accessories and packaging should be
disposed of for recycling in an environmentally
friendly manner.
Only for EU countries
Do not dispose of power tools into
household waste!
According to the European Guide
Lines 2002/96/EC for waste electric
and electronic equipment and its implementation
into national law, power tools that are no longer
usable must be collected separately and recycled in
an environmentally friendly manner.
Würth will gladly take back your defective Würth
power tool free of charge.
Warranty
For this Würth machine, we provide a warranty in ac-
cordance with statutory/country-specific regulations
from the date of purchase (proof of purchase by invoice
or delivery note). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or im-
proper handling is excluded from the warranty.
Claims can be accepted only when the machine is pre-
sented undisassembled to a Würth branch office, your
Würth sales representative or a customer service agent
for Würth power- and compressed air tools.

Noise/Vibration Information

Typically, the A-weighted noise levels of the tool are:
Sound pressure level 80 dB (A) ISO NP/11204;
Sound power level 90 dB (A) ISO/DIS 3744.
Wear ear protection!
The typical hand-arm vibration is below 2.5 m/s
(ISO 5349-2)

Declaration of Conformity

We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents:
EN 55014-1:2006, EN 61000-3-2:1998,
EN 61000-6-2:2005, ISO NP/11204,
ISO/DIS 3744, EN ISO 12100-1:2003+A1:2009,
EN 60204-1:2006, ISO 5349-2:2001 according to
the provisions of the regulations 2006/42/EG,
2006/95/EG, 2004/108/EG.
10
Technical file at:
Adolf Würth GmbH & Co. KG, Abt. PFW
D-74650 Künzelsa
Künzelsau: 14.01.2010
N. Heckmann
Subject to change without notice
u
A. Kräutle
2 .
13