BH FITNESS H-283 Manual Del Usuario página 8

FITTING THE BATTERIES.-
This monitor
ALKALINE BATTERIES. To fit the
batteries, remove the rear cover on
the monitor, Fig.1, and carefully insert
the two "R-6" type batteries into the
battery compartment (A) making sure
that the battery's polarity is correct
(matching the battery's «+» terminal
with the «+» sign inside the battery
compartment, and the «-» terminal
with the «-» sign). Close the cover, as
shown in Fig.1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
The monitor will switch itself off
automatically if
motionless for 3 minutes.
Important:
components in special containers, Fig.2.
FITTING THE ELECTRONIC
MONITOR.-
Remove the screws from the base of
the monitor, connect the terminals for
the feedback cable (21) to those on
the monitor (32), Fig.3, then slide the
front of the monitor down onto the
plate on the main post (4), making
sure not to snag any of the wires, fit
the screws and tighten, plug the
terminal for the handgrip (24) into the
rear of the monitor, Fig.4.
uses two 1.5
the unit remains
Deposit electronic
English
ELECTRONIC MONITOR.-
volt To give you greater control over the
exercise, this electronic unit provides
simultaneous
distance, exercise time, calories burnt
and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
The monitor will switch itself off
automatically if the unit stands idle for
more than 3 minutes.
A.SCAN FUNCTION.-
In SCAN
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
To select the SCAN function:
1. The monitor starts in SCAN mode
as soon as exercise begins or if any
key is pressed, the main screen will
display TIME, SPEED, DISTANCE,
CALORIES, PULSE RATE values
every 8 seconds, this value will also
be displayed flashing on the lower
section of the monitor.
2. Press the MODE key and this will
cancel the SCAN function.
B.TIME FUNCTION.-
This function counts up or down in
steps of one second, up to a
maximum of 99:00 seconds. Pressing
the DOWN key for more than two
seconds will reset all of the values,
except those relating to personal
information.
1. Press any key to switch the monitor
on.
8
read-outs of
mode the computer
speed,