Installation Instructions - Presto 18585 Manual De Instalación

ENGLISH

1) INSTALLATION INSTRUCTIONS

2) Self-supporting frameworks for anti-vandalism tank flush
3) PRECAUTIONS FOR USE (The product guarantee depends on the respect for these rules)
INSTALLATION and START UP
For products delivered with filters, these must be installed in accordance with the instructions.
Before commissioning any of our valves, it is essential to carefully drain
the pipes that can damage the mechanisms or water passages (PRESTO® heads that can be dismantled from front).
Recommended operating pressure according to NF EN 816: 1 to 5 bars.
CLEANING
The chrome-plated coating of PRESTO® valves must be cleaned only with soapy water.
Abrasive, acid, alkaline or ammonia-based household products are prohibited.
4) Tank framework for anti-vandalism control Part no. 18585
5 Technical characteristics:
- Male feed G1/2"
- Shut-off valve
- Junction nose for bowl Ø 55
- Pipe and WC drain ring Ø 90/100
6) ! The framework must be covered with 2 BA13 plates. Max wall thickness: 90 mm
7) Framework and ceramic installation
8) * To be used in case of not very resistant floor
9) I TANK
10) 1 – Brass coupler 1/2" male
2 – Supply hose
3 – Shut-off valve
4 – Filling float valve
5 – Emptying mechanism
6 – Cover
7 – Control cable for anti-vandalism face
11) II Water inlet connection
12) Connect the water inlet to the brass coupler 1/2" male (1)
13) III Protection
14) Install the template (J)
15) Close the cover of the template
16) IV Installing the control plate
17) Cut the template (J) directly below the wall
18) Cut the 2 screws (K)
19) Fix the frame of the control plate (F) using 2 screws (K)
20) Clip the control cable (7) on the button (4a) of the plate (F)
21) VI Maintenance
22) Replacing - Filling float valve: Part no. 90787
- Membrane for float valve (delivered by 5): Part no. 90788
23) Use a 19 flat key (9) to unscrew the hose (2).
24) Pull along the arrow (9a) and raise according to the arrow (9b) simultaneously to remove the float valve (4) from its
housing
25) Replacing - Control cable for anti-vandalism face: Part no. 90785
- Emptying mechanism: Part no. 90784
- Emptying mechanism membrane (x5): Part no. 90786
26) Unclip and raise the support (10) according to the arrows (10a) and (10b).
27) Rotate the draining mechanism (5) according to the direction of the arrow (11a) then remove from the tank
according to the arrow (11b).
28) For the disassembly of the control cable (7) press simultaneously according to the arrows (12a)
29) This document is not contractual; we reserve the right to modify the characteristics of our products without notice.
30) PATENTED and REGISTERED MODELS