Brod & Taylor FP-201 Instrucciones página 5

GENERAL OPERATING INSTRUCTIONS
Set Up
Open the lid by lifting the front edge of the Proofer. Allow the lid to rest in a vertical
position. Remove the wire rack and water tray. Lift the expanding box section from the
front edge, allowing it to remain attached to the base at the back so it can pivot
open. Fold it open and fi t into the base.
Place the water tray on the center of the heating plate. Place the wire rack into the
enclosure with feet down. Lift the lid straight up from the rear hinges and place onto
the top of the expanded box, fi tting the guides on the lid into the matching grooves.
Lower the lid to a closed position. Plug the power cord into the Proofer and then into an
appropriate receptacle.
For Set Up, Do Not Remove Folding Walls
If the folding walls are removed from the base, it may be more time-consuming to set
up the Proofer.
Pre-Heat
For best results, the Proofer should be pre-heated for 10-15 minutes.
Operation
Plug the Proofer in. Press the ON/OFF button once and ensure that the green
POWER light is illuminated. Depress the UP or DOWN buttons to adjust to the desired
temperature. Press and hold either the UP or DOWN button for three seconds to
quickly scroll through the temperature settings.
Page 5