Humidity Control; Cleaning And User Maintenance - Brod & Taylor FP-201 Instrucciones

The HEATING light will illuminate indicating that the heat plate is warming up. When the
Proofer reaches its temperature set point the HEATING light will go off. It is normal for
the HEATING light to fl ash on and off as the Proofer maintains its temperature during use.
Select Celsius or Fahrenheit
The display on the control panel indicates the temperature set point. The display may
be confi gured to display in °F or °C. To switch between modes, press and hold both the
"Temperature UP" button and the "Temperature DOWN" button for two seconds.

Humidity Control

The Proofer may be operated in a dry or humid condition. To create a humid condition
in the Proofer, pour approximately ¼ cup (50ml) of water into the water tray. DO NOT
overfi ll the tray. For best results, warm or hot tap water may be used.
Prepare for storage
If the Proofer is ON, press the ON/OFF button once to turn the Proofer off. Ensure that
the green POWER light is not on. Remove the lid and rest it in the rear hinges in an
upright position. Unplug power cord from the wall receptacle and the Proofer.
NOTE: The power cord must be unplugged before folding the Proofer and closing the
lid. If the Proofer is warm, let it sit with the lid removed until the heating plate reaches
room temperature. Remove the wire rack. Carefully remove the water tray, dispose
of remaining water and set aside. If necessary wipe surfaces of the Proofer with a
damp cloth to remove any water residue. Make sure the Proofer is dry before folding
for storage. Lift the expanding box section slightly from the front, then fold by pushing
gently in on the sides and folding the unit towards the back. Lower the folded section
into the base. Place the water tray into the front section of the base. Orient the wire
rack with feet up and place it on the base. Remove the power cord from the Proofer.
Lower the lid closed and press on the front to ensure that the latch is engaged.

CLEANING AND USER MAINTENANCE

1. This appliance is virtually maintenance free, no lubrication is needed. If the cord or
the appliance is damaged or does not operate properly, return it to service for repair.
This appliance has no user serviceable parts. No repairs should be attempted by
the user.
2. Always disconnect from the socket and completely cool down before cleaning.
3. Do not leave water in the water tray for long periods. Wait until the heating plate has
cooled before emptying the tray.
4. If necessary, wipe the housing and metal heating plate with a damp cloth or
moistened with a mild detergent solution. Do not use chemical or abrasive cleaners,
polishers, etc. Do not immerse the appliance in water or place it under running water.
5. Wash all removable parts and accessories with care in warm soapy water if
necessary, or simply wipe with a soft cloth moistened with a mild detergent solution.
6. After cleaning, wait until completely dry and cooled down before folding up
the appliance for storage. The wire rack and water tray can be put inside for
self-storage.
Page 6