Overheat Protection - turbionaire AMBIO 90 Manual De Instrucciones

b. When the unit is working at the above a. situation, press "COOL" button in the
Remote controller, receiver receives the signal with the sound of "beep" and switch high
speed to low speed "L". Meanwhile there is a green light display in the receiver. Press
"COOL" button again, the unit will switch low speed to high speed. So when the unit is
working at cool mode, press "COOL" button can switch air curtain working under the
cycle of Low or High speed.
c. When the unit is working at the above b. situation, press "HEAT" in the remote
controller, receiver receives the signal with the sound of "beep" and switch cool mode to
heating mode at low power. Meanwhile there is a Red light display in the receiver. Press
"HEAT" button again, the unit will switch low power to middle power. Meanwhile there is
TWO Red lights display in the receiver. Press "HEAT" button again, the unit will switch
middle power to high power. Meanwhile there is THREE Red lights display in the receiver.
Press "HEAT" button again, the unit will switch heating mode to cool mode and the red
lights display change to green light in the receiver. So HEAT function, when the unit is
working at cool mode, press "HEAT" button can switch air curtain working under the
cycle of heating low power, heating middle power, heating high power and then cool
mode.
d. When the unit works at cool mode, press "ON/OFF" button to turn OFF the unit.
e. When the unit works at heating mode, press "ON/OFF" button, the unit will
switch to cool mode at high speed, the indication light turns to green flicker light. The
unit will continue to work in cool mode for 30 seconds and then stop.(This is to ensure
the heater is been cooled down and has 30 seconds delay stop).
7.2.2. Controlled by the control panel in the unit is the same function as 7.2.1.
7.2.3.

Overheat protection:

When the air curtain works at heating mode, there is overheat protection. When the
heater temperature is overheating, heating mode will stop and switch to cool mode
automatic, at the same time the indication light change to green light. When the
temperature drop down to a certain temperature, if want the unit to work at heating
mode, press "HEAT" button to continue to work heating mode.
7.3 According to the installation place to adjust the wind direction vanes to obtain
the best effect.
8. CAUTIONS
1) Turn off the power and disconnect the plug for any maintenance service.
2) Turn off the power or disconnect the plug in case of not use the product for long
time.
3) Make sure that the product connected with ground wire.
4) The pictures shown on this manual are illustrative only.
5) This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety.
6) Children should be supervised to ensure that they do not play with the appliance.
7) If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
9. ATTENTION
a) Use the unit at the rated voltage and frequency indicated on the nameplate.
b) Do not wet the product electrical components.
c) Never use petrol, benzene, thinners or any other such chemical to clean the unit.
d) Routine maintenance must be done every year.