Hoefer UVC5000 Manual Del Usuario página 15

Note: The time exposure is
set in minutes and tenths
of a minute.
•
p6
Preset UV time exposure
1
Push PRESET and then TIME on the tactile touch
pad. The red light at each position should now be
lit and the preprogrammed UV exposure time of
2 minutes should be displayed on the LED.
2
Push START on the touch pad. After a slight delay to
energize the UV tubes, the LED will begin to count
down. The unit will automatically stop at the end of
the exposure cycle and will beep five times.
Exposure is now complete.
Optional: Though the preset UV time exposure is
factory set to 2 minutes, it is possible to change this
if necessary, as follows:
• Push and hold the PRESET button on the touch
pad until you hear an audible signal, then push the
TIME button on the touch pad.
• Set your new preset UV time exposure by inputting
the numbers on the touch pad. The new setting will
appear on the LED display.
• Push ENTER on the touch pad. The new setting is
now established.