Preparations; Installation - Rational Combi-Duo Gas Manual Del Usuario

en
Bottom unit: Top unit
Gas unit
6-1/1 Gas 6-2/3 or
right-sided 6-1/1 Elec-
hinge tric/Gas
6-2/1 Gas 6-2/3 or
right-sided 6-1/1 /
hinge 6-2/1 Elec-
tric/Gas
6-1/1 Gas 6-2/3 or
left-sided 6-1/1 Elec-
hinge tric/Gas
6-2/1 Gas 6-2/1 Gas
left-sided left-sided
hinge hinge
You can find further information on other
Combi-Duo variants, such as with gas
units as the bottom unit, in the associated
installation manuals.
Scope of delivery [
1 Base plate top
3 Feet at front
5 Exhaust gas stack
7 Shaft cover
9 Ethernet cable
Dimensions
Note that with a Combi-Duo system, the
connection heights and access heights
change for both units. You can find draw-
ings of the setup and precise dimensions
and height of the top rack rail for the dif-
ferent configurations in separate dimen-
sion drawings.
NOTICE! If the rack height is over 1600
mm [63 inches], affix the safety label to
the unit.
Key for dimension drawings:
1 Height of top
rack
12 / 80
Article num-
ber
60.75.751
60.75.752
60.75.753
60.75.754
Photo 01]
2 Base plate below
4 Feet at the rear
6 Heat protection
cover
8 Exhaust pipe
2 Top unit access
height
80.51.374_iCombi Pro-iCombi Classic_CD G_IM_V02_Eur-west
3 Bottom unit ac-
cess height
5 Height of bottom
unit water drain
4

Preparations

Position the bottom unit
In order to position the bottom unit for the
Combi-Duo setup, mount the unit onto a
stand with feet, castors or a levelling kit.
Note that the wall clearance of the Combi-
Duo unit is at least 50 mm [1.97 inches].
Note the description in the unit's installa-
tion manual for positioning the unit on the
stand.
Align the bottom unit
Align the stand: Position the unit and
n
check the alignment with a spirit level
in the cooking cabinet. If necessary,
align the castors or feet evenly so that
the unit is standing securely.
Align the levelling kit: Align the level-
n
ling kit and check the alignment with a
spirit level before positioning the
lower unit on the levelling kit.
5

Installation

Setting up the Combi-Duo and the top
unit
NOTICE
Mounting and attachment of the top
unit on the top base plate
The top unit is attached to the top base
plate with only three screws. The fourth
attachment is difficult to access through
the cover for flue pipes and is not
absolutely necessary.
4 | Preparations
4 Height of top
unit water drain