ARIETE RoboMax metal 1768 Manual De Instrucciones página 11

DESCRIPTION OF THE APPLIANCE (Fig. 1)
A Operating dial
B Power base
C Blender
D Blender lid
E Blender lid filler cap
F Blade support
G Chopping blade
H Mixing blade
I Pusher
L Small pusher
WARNING
The appliance is fitted with a device to stop it from operating if the lid (N) is not correctly
locked into place and the bowl (V) or alternatively, the blender (C), is not correctly inserted.
INSTRUCTIONS FOR USE
- Before use, clean all parts that will come into contact with foods, using a cloth and hot water with
a mild detergent. Dry thoroughly.
- Place the bowl (V) on the power base (B) and lock it in place by turning it clockwise so that the tab
on the bottom of the bowl clicks perfectly into place in the slot in the power base (Fig. 2).
- Fit the blade support (F) onto the central shaft in the bowl (V) (Fig. 3).
WARNING:
Make sure that the appliance is unplugged and that the control dial (A) is set to "0" before
cleaning it or fitting or removing attachments.
Chopping or mixing
- To use the appliance as a chopper, fit the metal blade (G) onto the blade support (F), while for
mixing, fit the plastic blade (H) by making sure that the slots inside the base of the blade are in
line with the notches in the support and pressing the blade downwards (Fig. 4).
- Cut the foods into small pieces (1.5 x 1.5 cm) and place them inside the bowl (V) or for mixing,
insert the ingredients.
- Fit the lid (N) over the bowl (V) so that the tabs inside the bowl fit perfectly into the slots on the lid
and click them into place by turning clockwise (Fig. 5). Lock the lid of the food presser (I) housing
using the special button (M).
- Plug the appliance into the mains power.
- Start the appliance, selecting the rotation speed of the blade using the operating dial (A).
The appliance has two operating speeds: minimum "1" and maximum "2".
Note: When using the appliance for mixing or whisking, the recommended operating speed is "1".
It is also possible to select the pulse function by turning the dial (A) anticlockwise to the setting
«P». For the best use of this function, only turn the dial for a very short time (2-3 sec.).
M Lock button
N Lid
O Blade disc
P Chip cutting blade
Q Blade for fine slicing
R Blade for fine julienne slicing
S Blade for thick slicing
T Blade for thick julienne slicing
U Spatula
V Bowl
- 9 -
EN