Bimar TORNADO VC91 Folleto De Instrucciones página 7

Fax +32 030 9904733
• The appliance must be kept out of children's reach.
• Attention: when using electric appliances, the basic safety precautions must always be
observed to avoid risks of fire, electric shocks and physical injury.
• Do not use the appliance if it is not operating correctly or seems damaged; if in doubt, contact
professionally qualified personnel.
• Always unplug the appliance before you assemble, disassemble or clean the appliance.
• Do not use the appliance if it is not operating correctly or seems damaged; if in doubt, contact
professionally qualified personnel.
• Make sure that the appliance is working correctly: if not, turn the appliance off and have it
checked by professionally qualified personnel.
• Do not move the appliance when it is operating.
• Unplug the appliance when not in use.
• Do not leave the device exposed to the weather (sun, rain, etc.).
• Do not touch the appliance with wet hands or feet.
• Do not pull on the cord to move the appliance.
• Do not pull on the cord to disconnect the plug from the socket.
• If the supply cord is damaged, it must be replaced by the manufactuer, its service agent or
similarly qualified persons in order to avoid a hazard.
• Do not use the appliance with a timer or a programmer or with a system that can switch
on the appliance automatically, to avoid risk of fire, since a fire risk exists if the appliance is
covered or positioned incorrectly.
• If the appliance breaks down or there is a malfunction, switch off the appliance and have it
checked by qualified personnel; repairs carried out by unauthorised personnel may be
dangerous and invalidate the guarantee.
INSTALLATION
• After removing the packing materials, check the integrity of the heater; if you are unsure, do not use it
and ask for qualified professional help. The packing materials (plastic bags, polystyrene foam, nails,
etc.) must be kept out the reach of children because they are potential sources of danger.
• Before connecting the appliance, check that the voltage values shown on the data plate correspond to
those of the electricity supply network. In the event of incompatibility between the electric outlet and
the plug of the heater, have the outlet replaced with another more suitable type by professionally
qualified personnel, who will make sure that the section of the wires of the outlet is appropriate for the
absorbed power of the heater. In general, the use of adapters or extension cords is not recommended; if
their use is indispensable, they must conform to existing safety standards and their current capacity
(amperes) must not be less that the maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Beforeeach use, checkthattheequipmentis in goodcondition, and thatthepower cable isnotdamaged: if in
doubtconsult a qualifiedprofessional.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
7 24
/
Assembly page 7/24