BH FITNESS H-491 Manual De Instrucciones página 7

FITTING THE BATTERIES.-
This monitor
ALKALINE BATTERIES. To fit the
batteries, carefully insert the two "R-6"
type batteries
compartment (A), Fig.1, making sure
that the battery's polarity is correct
(matching the battery's "+" terminal
with the "+" sign inside the battery
compartment, and the "-" terminal with
the "-" sign). Replace the battery
compartment cover.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important. Deposit all spent batteries
or waste packaging
containers, Fig.2.
FITTING THE ELECTRONIC
MONITOR.-
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connector
(Z), sticking out of the main post (6),
and plug it into (V) located at the back
of the monitor (P), as shown in Fig.3.
ATTACHING
CABLE.
Take hold of cable (X), which is
sticking up out of the main post, and
plug it into
connector (Y) at the back of the
electronic unit, as shown in Fig.3.
uses two 1.5
into the battery
in special
THE FEEDBACK
the «sensor iNput»
English
FITTING THE ELECTRONIC
volt
MONITOR.
Remove screws (4), Fig.1, from the
base of the monitor, then slide the
front of the monitor onto the plate on
the main post (6), Fig.3, making sure
not to snag any of the wires, fit the
screws (4) removed previously and
tighten securely.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit gives
simultaneous read-outs of speed and
rpm alternating with distance, exercise
time, calories burnt and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key on
the monitor. The monitor switches on
as soon as you start to exercise on the
machine.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes, with the screen
displaying the date and temperature.
SETTING THE DATE.-
Press the RESET key for 3 seconds to
reset the monitor, the year value will
flash. Press the MODE/ENTER key to
adjust the value. Use the ▲▼ wheel
UP/DOWN to move on to the month,
use the MODE/ENTER key to adjust.
Use the ▲▼ wheel UP/DOWN to
move
MODE/ENTER key to adjust. Use the
▲▼ wheel UP/DOWN to move on to
the hour, use the MODE/ENTER key
to adjust.
UP/DOWN to move on to minutes, use
the MODE/ENTER key to adjust.
7
on to the day,
Use the
use the
▲▼ wheel