Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
in order to reduce the drink outflow (see figure 5).
5. 3 CLEANING AND SANITIZING
PROCEDURES
1 - Cleaning
and
sanitizing
recommended to guarantee the conservation of the best
product taste and the highest unit efficiency. This section
is a procedural guideline only and is subject to the
requirements of the local Health Authorities.
2 - Prior to the disassembly and cleaning, the machine must
be emptied of product. To do this proceed as follows:
- set the power switch to I position
- set mixer/refrigeration switch(es) to I position (Soft Drink
mode)
- place a pail under each faucet and drain all product from
bowls
- set all control switches to the 0 position.
5. 3. 1 DISASSEMBLY
ATTENTION
Before any disassembly and/or cleaning procedure
make sure that the dispenser is disconnected from its
power source.
1 - Remove cover from the bowl.
2 - Remove the bowl by lifting its faucet side up and off the
fastening hooks (see figure 6) and slide it out (see figure
7).
figure 5
of
the
dispenser
figure 6
3 - Slide the outer spiral out (see figure 8) and then the inside
auger (see figure 9).
are
MT UL AF Black
figure 7
figure 8
figure 9
7
Publicidad
Tabla de contenido
