Black and Decker GL280 Traducción De Las Instrucciones Originales página 7

Before use, check the power supply cord and extension
u
cord for signs of damage, ageing and wear. If a cord
becomes damaged during use, disconnect the cord from
the mains supply immediately. DO NOT TOUCH THE
CORD BEFORE DISCONNECTING THE SUPPLY.
Do not use the appliance if the cords are damaged or worn.
u
Wear stout shoes or boots to protect your feet.
u
Wear long trousers to protect your legs.
u
Before using the appliance, check that your cutting path is
u
free from sticks, stones, wire and any other obstacles.
Only use the appliance in the upright position, with the
u
cutting line near the ground. Never switch the appliance
on in any other position.
Move slowly when using the appliance. Be aware that
u
freshly cut grass is damp and slippery.
Do not work on steep slopes. Work across the face of
u
slopes, not up and down.
Never cross gravel paths or roads while the appliance is
u
running.
Never touch the cutting line while the appliance is running.
u
Do not put the appliance down until the cutting line has
u
come to a complete standstill.
Use only the appropriate type of cutting line.
u
Never use metal cutting line or fishing line.
Be careful not to touch the line trimming blade.
u
Take care to keep the mains cable away from the cutting
u
line. Always be aware of the position of the cable.
Keep hands and feet away from the cutting line at all
u
times, especially when switching on the motor.
Before using the appliance and after any impact, check for
u
signs of wear or damage and repair as necessary.
Never operate the appliance with damaged guards or
u
without guards in place.
Take care against injury from any device fitted for trimming
u
the filament line length. After extending new cutter line
always return the machine to its normal operating position
before switching on.
Always ensure that the ventilation slots are kept clear of
u
debris.
Do not use the lawn trimmer (edge trimmer), if the cords
u
are damaged or worn.
Keep extension cords away from cutting elements.
u
Labels on appliance
+ The following warning symbols are found on the appliance:
F Read the manual prior to operation.
Wear safety glasses or goggles when operating this
appliance.
8
Keep people and animals at least 6 m away from the
R cutting area.
Do not expose the appliance to rain or high humidity.
# Electrical safety
This appliance is double insulated; therefore no earth
wire is required. Always check that the power supply
corresponds to the voltage on the rating plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features.
1. On/off switch
2. Handle
3. Cable restraint
4. Power inlet
5. Secondary handle
6. Tube
7. Storage hooks
8. Adjustment button
9. Guard
10. Line trimming blade
11. Cutting line
12. Spool housing
13. Edge guide
14. Head
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Attaching the tube to the head (fig. A)
Align the rectangular tab of the tube (6) with the location in
u
the head (14).
Insert the tube into the head and push until it clicks into place.
u
Attaching the handle to the tube (fig. B)
Align the square tab of the tube (6) with the location in the
u
handle (2).
Insert the tube into the handle and push until it clicks into
u
place.
Fitting the guard (fig. C)
Remove the screw (15) from the head.
u
Place the guard onto the tool as shown.
u
Firmly press the guard (9) until it snaps into place.
u
ENGLISH
7