V-TAC VT-5129 Manual Del Usuario página 5

DELETING ADDITIONAL SWITCH FROM A PAIRED SWITCH
Press and hold paired switch panel for about 60s, during which LED indicator on switch changes
from: firstly blinks rapidly; secondly blinks 8 �mes slowly, thirdly blinks 9 �mes at slower speed,
finally blinks once at slowest speed, then loosen
UNPAIRING THE RECEIVER
Press and hold the receiver bu�on for about 10s, loosen you finger when indicator light changes
from rapid blinks to slower, press the paired switch panel cannot control the lamps
HOW TO SET OPEN/CLOSE STATE OF RECEIVER TO MAKE
WIRELESS SWITCH COMPATIBLE WITH TRADITIONAL
SWITCH
Note: The receiver is default in Close state.
1. Power off the electricity, install the receiver as the diagram, and dis�nguish live from neutral
lines.
2. Power on the electricity, then program receiver with the switch according to the Learning
code Opera�on chapter
FIGURE 11
WIRELESS SWITCH
FIGURE 9
FIGURE 10
TRADITIONAL
SWITCH
WIRING DIAGRAM OF ADD WIRELESS SWITCH
TO TRADITIONAL SWITCH.
ENGLISH