VATECH EzRay Air Manual Del Usuario página 43

Charging the Battery
1. Connect the battery charger to the battery charger connector as shown in the
following figure.
2. When the battery charger is connected, the battery charging LED indicator light
comes on. Charge the battery until all the three LED indicators are filled up.
3. When the battery charge is completed, remove the battery charger from the
device.
Battery Use Cycle
Battery is a consumable part. It is expected to degrade gradually, so it should be
recharged more frequently. When the battery duration decreases to half or less than
half compared to when the battery was new, contact your Service Representative to
get a new battery.
To check how to replace the battery, see 'Battery Replacement' on page 34.
EzRay Air (Model: VEX-P300) User Manual
Usually it takes about 3 hours to fully charge the battery after complete
discharge.
You cannot perform an exposure while the battery charger is connected
to the device.
3. Operation
33