Inserting The Battery; Switching On And Off - Wurth Master 22-180 H Manual Original

OBJ_BUCH-1029-001.book Page 12 Tuesday, June 30, 2009 4:39 PM
The lithium ion battery can be charged at any time without reducing its
service life. Interrupting the charging procedure does not damage the
battery.
The lithium ion battery is protected against deep discharging by the
"Electronic Cell Protection (ECP)". When the battery is empty, the cordless
worklight is switched off by means of a protective circuit.
Do not continue to press the On/Off switch after
WARNING
the cordless worklight has been automatically
switched off. The battery can be damaged.
To remove the battery 3, press the battery unlocking button 4 and pull
the battery out of the cordless worklight toward the rear. Do not exert
any force.
The battery is equipped with a NTC temperature control which allows
charging only within a temperature range of between 0 °C and 45 °C.
A long battery service life is achieved in this manner.
Observe the notes for disposal.
Starting Operation

Inserting the Battery

❏ Use only original Würth lithium ion batteries with the volt-
age listed on the nameplate of your power tool. Using other
batteries can lead to injuries and pose a fire hazard.
Insert the charged battery 3 into the handle until it can be felt to engage
and faces flush against the handle.

Switching On and Off

❏ The cordless worklight produces a light beam that emerges
from the lamp head 1.
To start the cordless worklight, press the On/Off switch 2.
To switch off the cordless worklight, press the On/Off switch 2 again.
Protection Against Deep Discharging
The lithium ion battery is protected against deep discharging by the
"Electronic Cell Protection (ECP)". When the battery is empty, the cordless
worklight is switched off by means of a protective circuit.
12–English
30.6.09