Cleaning And Maintenance; Cleaning; General Maintenance; Removal Of Clogging And Blockage - FLORABEST FLS 3000 B2 Traducción Del Manual De Instrucciones Original

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 89
5. Mount the emptied collection
bag again.
Composting material does not be-
long with domestic waste!
Cleaning and
maintenance
Always clean the device
immediately after working with
it, as otherwise dirt will become
hardened and firmly attached
with leaf residues and might prove
impossible to remove without
dismantling the motor housing.
Such cleaning work is not covered
by the warranty.
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing and remove
the mains plug
Do not use any cleaning agents or
solvents. Chemical substances may
attack the plastic parts of the de-
vice.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or solvents.
You may otherwise irreparably dam-
age the appliance.

General maintenance

• Prior to every use, check the appli-
ance for obvious defects such as loose,
worn or damaged parts. Check that the
screws in the cutting disk are tight.
• Check covers and safety devices for
damages and correct installation. Re-
place as necessary.
Removal of clogging
and blockage
Leaf material and fresh plant parts may
clog / block the device.
Cleaning the impeller wheel:
Pull out the mains plug!
There is a risk of injury!
1. Remove the protective cover (
and/or the suction tube (
2. Carefully remove residues or clogging
materials from the impeller wheel.
3. Check to make sure the impeller wheel
is easier to turn and is in undamaged
condition. Have our Service Centre re-
place a defective impeller wheel.
4. Retighten the protective cover (
and/or the suction tube (
If the protective cover (
or the suction tube (
correctly screwed into place by
hand, it is not possible to operate
the device.
GB
IE
7)
A
B
C
16).
A
B
C
D
K
L
M
K
L
M
N
U
V
W
U
V
W
X
7)
A
B
C
16).
A
B
C
D
K
L
M
K
L
M
N
7) and/
A
B
C
D
U
V
W
16) is not
A
B
C
D
U
V
W
X
K
L
M
N
K
L
M
N
U
V
W
X
U
V
W
X
33
D
E
N
O
X
Y
D
E
N
O
E
X
E
Y
O
O
Y
Y

Publicidad

Tabla de contenido
loading

Tabla de contenido