Transportation - V-TAC VT-2000WRD Manual De Instrucciones

ENGLISH
4. Press the power button on the touch panel or remote control to activate the heater. The device will enter
standby mode displaying (25°C-27°C) on the LCD display.
5. Press the Mode button on the control panel/ remote control (Figure 2 and Table 1), the device will start in
Low temperature heating mode. You can switch between Frost-Low temperature and High temperature mode
by using the mode button on the control panel/ remote control (Figure 2 and Table 1)
Modes: Tap on the Mode button on the touch panel/ remote control (Figure 2 and Table 1) to switch between
Frost-Low-High modes.
Frost Mode: Operates at 1.5W (Designed with a thermostat, frost mode ensures keeping small rooms free
from frost).
Low temperature Mode: Operates at 1000W (Allowing the temperature range to be set from 15°C-35°C.).
High temperature Mode: Operates at 2000W (Allowing the temperature range to be set from 15°C-35°C.).

TRANSPORTATION

Please ensure to transport the device properly, failure to do so may result in damaging the device.
Before transporting or moving or adjusting the device please ensure to follow the below steps.
1. Switch off the power and unplug the mains plug from the mains socket.
2. Ensure the device is cooled down properly.
3. If the brake was applied, release the brake from the wheels.
4. Now you can transport or move the device. Do not use the power plug to move or transport the device.
12