SCHOLTES B 40 L EC Serie Manual De Instrucciones página 27

The timer operating period can be set to a duration of
anywhere between 0 and 99 minutes.
To shut of the timer function before the time has
elapsed, press the – button (T3) until the value 0 is
reached, or press the buttons + and – (T3 and T4)
simultaneously.
ADDITIONAL NOTES ADDITIONAL NOTES
ADDITIONAL NOTES ADDITIONAL NOTES ADDITIONAL NOTES
If a burner cannot be switched on or off, after
attempting automatic re-ignition (for a maximum
period of 6 seconds), the signal F2
will flash on the display corresponding to that burner.
When the hob is ON and the burners switched off, if no
activity is detected on the keypad after 1 minute, a
buzzer sounds and the keypad is locked (the
display D1 is activated); after a further minute a
buzzer sounds again and the hob switches off once
and for all, with the keypad remaining locked.
Nevertheless, in every operating status (off, hob on and
burners off, or hob and burners on), after 1 minute of
inactivity on the keypad it will become locked.
After an hour of operation with no adjustments made to
a particular burner, the burner will switch off.
To achieve the maximum burner performance level, we
recommend that only cookware with a suitable
diameter for the relevant burner is used, thereby
preventing the flame from leaking out from under the
base of the pan (see table below).
Furthermore, when a liquid begins to boil, we
recommend that the flame is reduced to the lowest
level possible to keep the pan contents boiling.
ø ø ø ø ø
BURNER BURNER BURNER BURNER BURNER
A. A. A. A. A. Auxiliary 6 - 14 6 - 14 6 - 14 6 - 14 6 - 14
B. B. B. B. B. Semi-rapid 15 - 22 15 - 22 15 - 22
15 - 22 15 - 22
C. C. C. C. C. Rapid 18 - 26 18 - 26 18 - 26 18 - 26 18 - 26
F2 F2 (fault indication) F2 F2
Pan diameter (cm) Pan diameter (cm) Pan diameter (cm) Pan diameter (cm) Pan diameter (cm)
To ensure the burners operate efficiently: All types of
deep casserole dish may be used on the burners, as
long as the edges of the cookware do not overlap the
perimeter of the hob. The most important thing is that
the base of the cookware is perfectly flat.
After a burner has been switched off, "H" will flash After a burner has been switched off, "H" will flash After a burner has been switched off, "H" will flash After a burner has been switched off, "H" will flash After a burner has been switched off, "H" will flash
on the corresponding display to indicate that the on the corresponding display to indicate that the on the corresponding display to indicate that the on the corresponding display to indicate that the on the corresponding display to indicate that the
burner is still hot. burner is still hot. burner is still hot. burner is still hot. burner is still hot.
If the hob is switched off (button T1), this signal If the hob is switched off (button T1), this signal If the hob is switched off (button T1), this signal
If the hob is switched off (button T1), this signal If the hob is switched off (button T1), this signal
will become fixed instead of flashing, until the will become fixed instead of flashing, until the will become fixed instead of flashing, until the
will become fixed instead of flashing, until the will become fixed instead of flashing, until the
burner has cooled completely. burner has cooled completely.
burner has cooled completely. burner has cooled completely. burner has cooled completely.
When the appliance is not being used, make sure
that it is switched off (the burner displays are
switched off, or showing "H" if the burner is still
hot).
We also recommend that the main valve on the gas
supply piping is shut off.
GB
27