Princess 171110 Manual De Instrucciones página 14

­ Before cleaning or maintenance, remove
the mains plug from the wall socket and
wait until the appliance has cooled down.
­ Do not immerse the appliance in water or
any other liquids.
Before you proceed, we would like you to
focus your attention on the following notes:
­ Do not use aggressive or abrasive cleaning
agents to clean the appliance.
­ Do not use sharp objects to clean the
appliance.
• Regularly check the appliance for possible
damage.
• Clean the outside of the appliance, the pan
and the lid with a soft, damp cloth and a
few drops of washing­up liquid.
• Clean the basket and the steam rack in
soapy water.
• Clean the spatulas in soapy water.
• Thoroughly dry the appliance and the
accessories.
• Assemble the appliance.
• Wind the mains cable around the lugs at
the back of the appliance (fig. G).
• Store the appliance in a dry and frost­free
place, out of the reach of children.
Refreshing oil or fat
The oil or the fat must be refreshed regularly.
The useful life of the oil or the fat depends on
the frequency of use, the length of use, the
temperature during use, the quantity of food,
the nature of the food (e.g. spices used) and
the degree of cleaning of the oil or the fat.
During the deep­frying process, food
remnants, breadcrumbs and pieces of batter
that have fallen into the oil or the fat must be
removed. After the deep­frying process, the oil
or the fat must be filtered:
• Allow the oil or the fat to cool down.
• Drain the basket and remove the basket
from the pan.
• Put kitchen paper into the basket.
• Filter the oil or the fat through the basket
into a bowl of similar size.
To refresh oil or fat:
• Remove the lid and the basket from the
appliance.
• Put the oil or the fat in a container. Dispose
of the oil or the fat.
• Clean the pan with a soft, damp cloth and
a few drops of washing­up liquid.
• Thoroughly dry the pan.
• Fill the pan with fresh oil or fat just before
using the appliance again.
U.K. Wiring instructions
The wires in the mains lead are coloured in
accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
EARTH
GREEN/YELLOW
As the colours of the wire in the mains lead of
this appliance may not correspond with the
colour markings identifying the terminals on
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter L or coloured red.
The wire which is coloured GREEN/YELLOW
must be connected to the terminal which is
marked with the letter E or (
coloured GREEN or GREEN/YELLOW.
If a 13Amp (BS1363) plug is used, a 13Amp
(BS1362) fuse must be fitted, or if any other
type of plug is used, a 13Amp fuse must be
fitted, either in the plug or adaptor, or on the
distribution board.
Warning! This appliance must be earthed.
Disclaimer
Subject to change; specifications can be
changed without further notice.
14
) and is