Cognex In-Sight 2000 Serie Manual página 2

Regulations/Conformity
The vision sensor has Regulatory Model R00039 and meets or exceeds the
requirements of all applicable standards organizations for safe operation. However,
as with any electrical equipment, the best way to ensure safe operation is to operate
them according to the agency guidelines that follow. Please read these guidelines
carefully before using your device.
Regulator
USA
Canada
European Community
Australia
Japan
Note: For the most up-to-date regulations and conformity information, please
refer to the Cognex online support site: http://www.cognex.com/Support.
CAUTION: IP protection is ensured only when all connectors are attached to
cables or shielded by a sealing cap.
European Compliance
FCC 47 CFR Part 15 Subpart B, Class A
ICES-003
EN55022 (CISPR 22) Class A
EN55024:1998 +A1:2001 +A2: 2003
EN60950
C-TICK, AS/NZS CISPR 22 / EN 55022 for Class A Equipment
J55022, Class A
Safety and Regulatory
The CE mark on the product indicates that the system has been tested to and conforms
with the provisions noted within the 2004/108/EC Electromagnetic Compatibility
Directive and the 2006/95/EC Low Voltage Directive. For further information please
contact: Cognex Corporation, One Vision Drive Natick, MA 01760 USA.
Cognex Corporation shall not be liable for use of our product with equipment (i.e.,
power supplies, personal computers, etc.) that is not CE marked and does not comply
with the Low Voltage Directive.
2
Specification