Orbegozo CL 02105 M Manual De Instrucciones página 14

CL 02105 M - CL 04105 B - CL 06132 M
CL 08132 B - CP 20132 M - CP 25132 B
WIRING INSTRUCTIONS
Make sure to shut off the power of the point where you are going to install the ceiling fan.
There are four colored wires coming from the top of motor head.
Brown wire: Live (+) fan.
•
Blue wire: Neutral (-)
•
Green/Yellow wire: Earth wire
•
Black wire: Light (+)
•
Note: When making connections, twist the stripped copper threads of wires tightly together and
cap off with the wire connectors provided, again by twisting the connector firmly into the copper.
Connect the neutral wire from the fan (blue) to the neutral one in the electrical installation.
Connect the live wire from the fan (brown) together with the light wire (black) to the live one in the
electrical installation.
Connect the earth wire from the fan (green and yellow) to the earth one in the electrical installation.
Make sure that the bare copper of the wires are fully encased by the wire connectors, to prevent
electrical shock from occur.
OPERATION
1. Pull the light chain in order to turn it on and off.
2. Pull the fan pull-chain switch for sequence of high, medium, low, off in circles.
3. Fan reverse: The slide switch controls the direction of the fan, push the slide switch down for
forward, and up for reverse action of blades. (Normally, hot weather use forward and cold
weather use reverse for upward the air).
Warning: Before pushing the reverse slide switch, it is necessary to stop the action of the blades by
turning off the fan.
Important: The bulbs for this fan must be E27 / 60W max.
14