Using The Parking Aid; Troubleshooting - Dometic MWE 7006 Manual De Instrucciones

MWE7006
12

Using the parking aid

The sensors are activated automatically when you engage the reverse gear
with the ignition on or the engine running. An activation signal is emitted (two
short tones).
As soon as there is an obstacle within the detection range, a repeated signal
tone is emitted.
As you approach, the tone sequence changes, depending on the zone in
which the obstacle is, thereby indicating the distance.
Be very careful the first time you use the system, until you are familiar with
the various sequences of beeps.
!
WARNING!
Stop the vehicle immediately and investigate the situation (getting
out if necessary), if the following happens while you are manoeu-
vring:
the device first indicates an obstacle and the tone sequence
speeds up normally (e.g. from slow to medium) when manoeu-
vring. the signal tone suddenly slows down, or no obstacle is indi-
cated at all.
This means that the original obstacle is in the blind spot of the
sensors (construction-related characteristic), and there is still a
potential for collision.
13

Troubleshooting

The device shows no function.
The cables to the reversing light are not connected or are not properly con-
nected.
The plugs for the sensors are not connected or are not correctly plugged into
the control electronics.
➤ Check the plugs and make sure they lock into place.
EN
Using the parking aid
13