Black+Decker KFBES890 Manual De Instrucciones página 5

Injuries caused when changing any parts, blades or
u
accessories.
Injuries caused by prolonged use of a tool. When using
u
any tool for prolonged periods ensure you take regular
breaks.
Impairment of hearing.
u
Health hazards caused by breathing dust developed when
u
using your tool (example:- working with wood, especially
oak, beech and MDF.)
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured
in accordance with a standard test method provided by
EN 60745 and may be used for comparing one tool with
another. The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool along with the
:
date code:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Warning! Not a handle. Do not use as a
handle.
Electrical safety
#
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
(Original instructions)
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Lock-on button
3. Autoselect switch
4. Blade release button
5. Shoe / Branch steady
6. Blade clamp
7. Main handle
8. Secondary handle saw mode
9. Secondary handle jig saw mode
Fig. A
10. Large capacity blade
11. Fine tooth wood cutting blade
12. Fine tooth metal cutting blade
Assembly
Warning! Before attempting any of the following operations,
make sure that the tool is switched off and unplugged and that
the saw blade has stopped. Used saw blades may be hot.
Fitting and removing a saw blade
Warning! Take care when handling sharp blades. Always
wear gloves when fitting a blade.
Fitting
Press in and hold the blade release button (4).
u
Push the blade firmly into the blade clamp (6).
u
Release the blade release button (4).
u
Make sure the blade is securely fitted by trying to remove
u
it without depressing the blade release button (4).
Removing
Warning! The blade can become hot during use. Always wear
gloves when removing a blade.
Press in and hold the blade release button (4).
u
Pull the blade from the blade clamp (6).
u
Release the blade release button (4).
u
Use
Warning! Let the tool work at its own pace. Do not overload.
Warning! Before cutting into walls, floors or ceilings, check for
the location of wiring and pipes.
Switching on and off
To switch the tool on, push the lock-off button (2) into the
u
unlock position and press the variable speed switch (1).
To switch the tool off, release the variable speed switch
u
(1).
ENGLISH
5