Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Step 3. Entering WiFi details for your UFO camera
Pick the 2.4GHz WiFi network from the display list for your UFO camera and enter the WiFi
network password. The UFO will connect to the selected WiFi network. The binding process
should take about one minute.
When a successful connection is established, the indicators will run in succession.
Now, your UFO is ready for a spin!
Installation
Ceiling or Wall-Mounted
Step One:
Unlock the base from your camera.
Step Two:
Place the base on the wall, in the angle and relative position shown above; use
the provided tool set to install it properly.
Step Three:
Lock your camera into position onto the base.
Step Four:
Make sure the PIR motion sensor is pointing vertically to the ground.
EN
Publicidad
Tabla de contenido
