KALLISTA Circe P50202-00 Guia De Instalacion página 4

Bath
Load Lug
Beveled Washer
Freestanding Installation
2. Prepare the Bath
CAUTION: Risk of personal injury. Cast iron baths are extremely heavy. Obtain sufficient help to
carefully lift or move the bath.
CAUTION: Risk of product or property damage. Do not support the bath by the rim. Provide
adequate support under the feet.
For all installations:
Remove the bath from its carton and place it on a clean drop cloth or other protective floor covering
to prevent damage to the bath or floor.
For freestanding installations:
IMPORTANT! The two front legs on the drain end of the bath must be installed first. Obtain sufficient
help to lift the drain end of the bath to allow sufficient clearance for attachment.
Insert the head of the fastening bolt into the slot on the underside of the bath, as illustrated.
Place the leg, beveled washer, then nut onto the bolt. Using an adjustable wrench, tighten the nut to
secure the leg to the bath.
Insert the head of the leveling bolt through the bottom of the leg upward, as shown. Secure the
leveling bolt with a washer.
Wrench tighten a washer to the leveling bolt to secure the leveling bolt to the leg.
Repeat this procedure to install the remaining legs.
For all installations:
Install the drain to the bath according to the drain manufacturer's instructions. Do not connect the
trap at this time.
Position a clean drop cloth or similar material in the bottom of the bath. Be careful not to scratch the
surface of the bath.
Move the bath into place.
Insert the drain tailpiece into the trap.
1008431-2-A
Attachment Lug or
"drop-in" foot
Bath
Slot
Fastening Bolt
Leveling Bolt
4
Nut
Slot
Beveled
Washer
Leg
Washer
Underside of Bath
Bath
Kallista