Bimar ND-18D3CL Folleto De Instrucciones página 15

Chimenea eléctrica de baja
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

of fire, since a fire risk exists if the heater is covered or positioned
incorrectly. Check that no other high absorption appliances are
connected to the same power source.
• Do not use this heater the immediate surroundings of a bath, a
shower or a swimming pool.
• The heater must not be located immediately below a socket-oulet.
• If the suppy cord is damaged, it must be replaced by the
manufacturer, its service agent or a similarly qualified person in
order to avoid hazard.
INSTALLATION
• After removing the packing materials, check the integrity of the heater; if you are unsure, do
not use it and ask for qualified professional help. The packing materials (plastic bags,
polystyrene foam, nails, etc.) must be kept out the reach of children because they are
potential sources of danger.
All packaging elements must be disposed of according to their raw material (see the symbol
stamped on each one) and according to the provisions of their municipality. The bag
containing the set with brackets and fixing screws or the remote control, which is unmarked
due to its small size, is made of polyethylene; therefore you have to follow the procedures for
the disposal of this type of plastic.
• Before connecting the appliance, check that the voltage shown on the data plate matches
that of your electricity and that the electric plug is grounded. In the event of incompatibility
between the electric outlet and the plug of the heater, have the outlet replaced with another
more suitable type by professionally qualified personnel, who will make sure that the section
of the wires of the outlet is appropriate for the absorbed power of the heater (10A). In
general, the use of adapters or extension cords is not recommended; if their use is
indispensable, they must conform to existing safety standards and their current capacity
(amperes) must not be less that the maximum of the heater.
• Before each use, verify that the heater is in good condition and that the electrical cord is not
damaged: in the case of doubt, ask for professionally qualified help.
• Don't hang it on the wall.
• Make sure that the cable is correctly positioned and that it is not in contact with hot parts or
sharp edges, nor wrapped around the device or twisted.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
15/44

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Bihfp01

Tabla de contenido