ESX HORIZON Serie Manual De Instrucciones página 11

HIGH LEVEL INPUTS & AUTO TURN ON
The high level inputs under HI INPUT (Fig. 6) is suitable to connect the device input with speaker wires, if your
head unit is not equipped with pre-amplifier RCA outputs. Extend therefor every regarding speaker cable from
your head unit with appropriate speaker cables from your car audio retailer to the mounting location of the am-
plifier. Then connect the each matching loudspeaker cable with the cables of the included High Level Input jack.
CAUTION: Never use the high level inputs and the RCA inputs at the same time. This may damage the
device seriously.
The amplifier detects a voltage rise (6 Volts) with a so called "DC Offset" over the connected input signal on the
high level inputs under HI INPUT (Fig. 6) when the head unit will be switched on. Hence, the amplifier will also
be turned on. As soon as the head unit will be turned off, the amplifier turns also automatically off. In this case
the turn-on connection REM (Fig. 2,2) is not needed.
NOTE: The Auto Turn On function usually works with 90% of all head units, because they are equipped with
"High Power"-outputs. Only with a few older and head units the Auto Turn On function is not working.
INPUT SENSITIVITY
Turn the LEVEL INPUT (Fig. 1,7) controller of the amplifier to the MIN position. Then turn the volume controller
of the head unit to 80 - 90% of its full setting. Now turn LEVEL INPUT clockwise until you hear some distortion.
Then turn back the LEVEL INPUT slightly until you hear a cleaner sound.
VARIABLE SUBSONIC FILTER
With the SUB SONIC controller (Fig. 1,5) you can adjust the lower crossover frequency, to filter the very low
frequencies to relieve the subwoofer or to generate a bandpass signal. If you don't want to use this function,
turn the controller (Fig. 1,5) to the very left to the 10 Hz position.
NOTE: The adjusted value of the SUB SONIC (Fig. 1,5) should not be higher than the adjusted value of the
LOW PASS controller (Fig. 1,4). Otherwise no sound will be audible.
VARIABLE LOW PASS FILTER
Set the desired crossover frequency by using the controller LOW PASS (Fig. 1,4). Thus to that only the fre-
quencies below the chosen crossover frequency will be amplified and the subwoofer plays more precisely and
efficient.
VARIABLE BASS BOOST
By using the BASS BOOST controller (Fig. 1,3) you are able to increase the bass enhancement from 0 to 12
dB. ATTENTION: Use the BASS BOOST wisely!
PHASE SHIFT CONTROLLER
The PHASE SHIFT controller (Fig. 1,6) allows to adjust the phase between 0° and 180° to match the output
signal with the vehicle's interior acoustic.
BASS LEVEL REMOTE CONTROLLER
With the included bass level cable remote controller you are able to adjust the bass level e.g. out of the driver's
seat. Connect the remote controller and the REMOTE connector (Fig. 1,2) with the enclosed cable.
11