Publicidad
EN
4. When the buzzer stops, arm the K1/K2 system. If the system
alarms when walking in between the transmitter and receiver that
means the installation is successful and the sensors are functional.
5. Do not install the sensors at the following locations:
1. Areas where pets are active.
2. Dusty and muddy areas.
3. Within a 50 cm radius from power cables or network cables.
4. Near trees or plants, as leaves or trunks may block the infrared
beam.
Changing Batteries
You can check the battery status via the app. The LED light on the
receiver will also blink once every 3 seconds to indicate low battery.
When this happens, please change the batteries.
Specifications
Detector infrared beam:
4 beams
Transmitter battery:
2 x CR123A 3V battery
Receiver battery:
3 x CR123A 3V battery
Standby time:
3 years
Standby mode power consumption:
Transmitter < 0.03mA
Receiver <0.08mA
Alarm mode power consumption:
Detection range:
6m
Waterproof rating:
IP66
Radio Frequency:
868MHz(EAN 8719325039467) or 915MHz
*Only 868 MHz is available for Europe
Wireless transmission distance:
<80m (open area/no interference)
ERP (dBm) Max. :
-1.03
Case material:
PC+ANTI-UV
Operation condition:
Temperature: -20°C~+55°C
Humidity: <80% (non-condensing)
Dimensions (L x W x H):
42 x 47 x 612mm (Transmitter and Receiver are same)
16mA
EN
Publicidad
