Periodic Maintenance; Scrapping - Gastrodomus GRANISMART 3 Manual Del Usuario

CONFIGURATION 2
Remove the locking knobs from the rear door; remove the door and clean the
condenser using a dry brush.
Fig.75
After carefully cleaning the condenser, refi t the rear door.
7.10.2. Cleaning the condenser on
the Granita Maker (2/3 tanks)
The safety guards may be secured with screws or clips.
If the guard is fastened with screws, use a suitable screwdriver; if the guard is
fastened with clips, it may be removed by hand without the aid of any tools.
Fig.76
After removing the guard, use a dry brush to remove the dust that has built up
over time with use.
Fig.77
After thoroughly cleaning the condenser, fi t the guard back in place.
- 24_EN -

7.11. Periodic maintenance

The machine must be periodically checked (at least once a
year) by a specialised technician.
This periodic check serves to ensure that all the components
installed and the machine itself are maintained at a high level
of safety.
Any worn components must be replaced by an original spare part.
It is forbidden to use the machine when even only one of its
compone nts is faulty or worn. Users are forbidden to perform
periodic maintenance.

8. SCRAPPING

Electric and electronic equipment must be disposed of in ac-
cordance with European Directive 2002/96/EC.
Such equipment may not be disposed of as normal municipal solid
waste but must rather be separately collected to optimise recovery
and recycling of the materials used to manufacture them.
All products are marked with the crossed out wheeled bin
a reminder of separate collection obligations.
Correct observance of all of the provisions for the disposal of end-of-life prod-
ucts will contribute to safeguarding the environment.
symbol as
SL320000819 Ed.12 - 07-2013