Steinbach APPcontrol Manual Original página 45

Proceed as follows to clean your pool:
1. Insert the filter units.
2. Place the device in the pool.
3. Connect the control unit to the device and the power supply.
4. Switch the device on, select the desired type of cleaning and adapt the running time
to the size of your pool. See section "Functions of the control unit".
5. Start the cleaning program.
Inserting the filter units
1. Slide the filter units
device along the guide rail.
2. Press down the handle of the filter
units until it has snapped into place
1
on both sides.
The filter units are inserted.
flush into the
1
3
1
4
1
45